Value Added Services

Design Assistance

  • Confirmation (calculation) of Branch-Saddle Tee Reinforcement: Full Pressure (WPR)
  • Assistance with Design of fully pressure rated fabricated Assemblies.
  • Basic Design Drawing of pressure component fittings.
  • Quotation of Standard and Custom Fabricated Assemblies.

Technical Assistance

  • Brief Basic Discussions of Polyethylene Pipe and Fittings Design.
  • Development of Customized Technical Notes for specific applications
  • Fittings Recommendations and Transition Connections.

Plastic Pipe Consulting Assistance (Additional fees may apply)

  • Registered Professional Engineer, State of Texas
  • Expert Witness/Court Testimony/Depositions/Technical Litigation Support on Plastic Pipe.
  • Project Consulting and Engineering Design Analysis.
  • Project Proposals and Their Presentation.
  • Water Distribution System Conversion to HDPE from PVC & DI.
  • HDPE Distributor Training.
  • Literature and Product Presentation Development.
  • HDPE Pipe Project Proposals.
  • Marine Outfall Design Specialist.
  • NO-Dig Trenchless Technologies.
  • Product Testing and Analysis, New Product Standards Development.

Research and Development (Additional fees may apply)

  • Research and Development (Fee Paid Compensation)
  • New OEM fittings.
  • New Plastic Pipe and Fittings Manufacturing Processes.
  • New Plastic Pipe and Pipe Applications.
  • Validation Testing of Metallic Components on HDPE Pipe.

AWWA C906 Hydrotesting of HDPE Fittings and Assemblies. (Additional fees may apply)

Georg Fischer Central Plastics has its own AWWA C906 hydro-test unit located at its at its manufacturing plant located near Dallas, Texas.

While Georg Fischer Central Plastics LLC Pipe & Fabricated Products is not a certified laboratory, its resident Professional Engineer oversees the test work, procedures, and safety practices in compliance with the protocol and requirements of AWWA C906, section 2.4.0.